GO/NOGO Gauge Tolerance Calculator
GO and NOGO gauge sizes for any hole or shaft tolerance
Hole 42 mm H8: limits 42.0000 to 42.0390
+39 µm / +0 µm · work tolerance 39 µm
IS 3455 Table 2, over 30 up to 50 mm, IT8: Z 6 µm, H/2 2 µm, Y 5 µm
GO plug (new)
42.0060 ± 0.0020
Limits 42.0040 / 42.0080 mm
NOGO plug (new)
42.0390 ± 0.0020
Limits 42.0370 / 42.0410 mm
GO wear limit: 41.9950 mm (withdraw the GO gauge when it wears to this size)
IS 3455 method, sizes up to 180 mm. Plug: GO = K + Z ± H/2, NOGO = G ± H/2, wear limit K − Y. Ring/gap: GO = G − Z1 ± H1/2, NOGO = K ± H1/2, wear limit G + Y1. K and G are the lower and upper work limits. Verify critical gauges against the standard.
Get a quote for these gaugesHow GO/NOGO gauge sizes are worked out
A GO gauge is made at the maximum material limit of the feature and a NOGO gauge at the least material limit. For a hole, the GO plug sits at the lower limit and the NOGO plug at the upper limit. For a shaft, the GO ring or snap gauge sits at the upper limit and the NOGO at the lower limit.
The calculator follows the method of IS 3455 (aligned with ISO 1938) that our own gauge room uses. For a plug gauge the new GO size is K + Z ± H/2 and the NOGO size is G ± H/2, where K and G are the lower and upper limits of the hole. For a ring or snap gauge the GO size is G − Z1 ± H1/2 and the NOGO size is K ± H1/2. The GO gauge is withdrawn at its wear limit, K − Y for a plug or G + Y1 for a ring. Z, H and Y depend on the IT grade and size; the calculator takes them from IS 3455 Tables 2 and 3 for sizes up to 180 mm, and also gives the reference plugs (± Hp/2) used to set ring and gap gauges.
For a quick estimate without the standard, use the rule of thumb that the gauge tolerance is one tenth of the component tolerance, or one fifth where the component tolerance is very tight. The quick rule places the gauge tolerance inside the component tolerance, so a gauge anywhere within its own tolerance never accepts a bad part.
Limits for ISO fits come from ISO 286 for sizes up to 500 mm. For any other fit, switch to “Enter limits” and type the deviations from your drawing. Read more in our guide What is a GO/NOGO gauge?, or see our plain GO/NOGO gauges.
More: all tools · thread gauges · NABL calibration services