Plain Plug and Ring Gauges: How to Read H7 and g6 Tolerances
H7, g6, f7 and other fit codes decide the size of your plain plug and ring gauges. This easy guide explains what the letters and numbers mean, so you can order the right gauge from your drawing.
On many drawings you will see a hole marked as 20 H7 and a shaft marked as 20 g6. These codes tell you how much size variation is allowed, and they decide the gauge you need. The number, like 7 or 6, is the tolerance grade. A smaller number means a tighter tolerance. The letter shows where the tolerance zone sits compared to the basic size.
Capital letters like H are used for holes, and small letters like g are used for shafts. For an H7 hole, the zone starts at the basic size and goes slightly above it. For a g6 shaft, the zone is slightly below the basic size. When the shaft goes into the hole, the two zones decide whether the fit is loose, snug or tight.
A plain plug gauge checks holes, and a plain ring gauge checks shafts. Each one has a go end and a no-go end. The go end must pass through when the part is at its smallest limit for a hole or largest limit for a shaft, and the no-go end must not pass when the part is outside the other limit. So the gauge size is made from the limits of the fit code on your drawing.
When you order, send the basic size, the fit code, and the type of gauge you need. If the drawing has an unusual tolerance, send the drawing itself. S.V. Nanometrology manufactures plain plug and ring gauges and calibrates them in its NABL-accredited laboratory under one roof, so the certificate comes with your gauge. Write to info@svnanometrology.com or call +91 98732 67048.
Ask us about GO/NOGO gauges
Send your drawing or specification and we will reply with a quotation, usually within one working day. Every gauge is supplied with a calibration certificate from our NABL-accredited lab (ISO/IEC 17025, CC-2472).
- Manufacturer and exporter, supplying customers worldwide
- Made to your drawing, standard or sample
- Calibrated in-house before dispatch